Adhesive mixture for ceramic tiles up to 400x400 mm in size - TM 5

Field of application:

For gluing ceramic tiles with a size of no more than 400×400 mm with a water absorption of more than 3% on vertical and horizontal mineral surfaces that do not deform, inside and outside buildings.

Features:

high adhesion to the base;
excellent rheological properties;
for dry and wet rooms;
reliable fixing of tiles;
resistant to slipping from vertical surfaces

Advantages:

High adhesion and elasticity

Wet and dry rooms

Excellent rheology

Slip resistant

More about the product

Specifications

Storage	Cement, mineral fillers, polymer modifiers
Water consumption for 25 kg dry mixture, l	5.0....5.5
Consumption of dry mixture per 1 m² with a layer thickness of 1 mm	Approximately 1.5 kg
Expiry date, min	At least 60
Open time, min	At least 10
Adjustment time, min	At least 10
Adhesion strength to the base after: aging in air-dry conditions, MPa	Not less than 0.5
Coarseness of aggregate, mm	Not more than 0.8
Displacement of the material to be fixed (only for walls), mm	Not more than 0.5
Application temperature	From +5 ⁰С to +30 ⁰С
Operating temperature	From -30 ⁰С to +40 ⁰С
The time of possible technological movement, hours	Not before 48

Preparation of the base

The foundation is prepared in accordance with DSTU-NB A.3.1- 23:2013 and DSTU-NB V.2.6-212:2016. The surface of the base must be dry, strong, even, with low and uniform water absorption. Before applying the dry mixture, the surface is cleaned of dust, oil stains and other substances that reduce adhesion. Surfaces made of porous concrete, as well as gypsum and smooth concrete surfaces should be treated with a primer. Leave primed surfaces for at least 4 hours before starting cladding.
Preparation of the solution

Preparation of mortar mixture: pour water into a clean container (water temperature from +15 °C to +25 °C) at the rate of 0.20-0.22 l (l) per 1 kg (kg) of dry mixture (5.0-5 .5 l (l) per 25 kg (kg)), gradually add the dry mixture and mix with a low-speed mixer until a homogeneous mass without lumps is obtained. Keep the solution mixture for about 5 minutes, then mix again.
Recommendations

The use of dry mixture is recommended at temperatures from +5 °C to +30 °C and relative air humidity not higher than 65%. Eyes and skin should be protected during work. If the mixture gets into the eyes, it is necessary to immediately wash them with water and consult a doctor.

Execution of works

The mortar mixture is applied in a thin layer on the prepared base using a metal spatula or grater and smoothed with a toothed spatula. At one time, such amount of solution is applied that can be used within 15 minutes. The tile was not previously repl
Packaging

Paper bags with an inner polyethylene layer of 25 kg.
Storage

The mixture must be stored in original branded sealed package in a dry room, on pallets. The shelf life is 12 months from the date of manufacture indicated on the package
Cost

On average, 1.5 kg of glue is used per 1 m2, depending on the thickness of the applied layer and the condition of the surface.